Sliding-Mode Observer for Speed and Position Sensorless Control of Linear-PMSM
DOI:
https://doi.org/10.2478/ecce-2014-0003Keywords:
Permanent magnet motors, Motor drives, Observers, Sliding mode control, Sensorless controlAbstract
The paper presents a sliding-mode observer that utilizes sigmoid function for speed and position sensorless control of permanent-magnet linear synchronous motor (PMLSM). In conventional sliding mode observer method there are the chattering phenomenon and the phase lag. Thus, in order to avoid the usage of the low pass filter and the phase compensator based on back EMF, in this paper a sliding mode observer with sigmoid function for detecting the back EMF in a PMLSM is designed to estimate the speed and the position of the rotor. Most of conventional sliding mode observers use sign or saturation functions which need low pass filter in order to detect back electromotive force (back EMF). In this paper a sigmoid function is used instead of discontinuous sign function to decrease undesirable chattering phenomenon. By reducing the chattering, detecting of the back EMF can be made directly from switching signal without any low pass filter. Thus the delay time in the proposed observer is eliminated because of the low pass filter. Furthermore, there is no need to compensate phase fault in position and speed estimating of linear-PMSM. Advantages of the proposed observer have been shown by simulation with MATLAB software.References
J. Batelaan, “A Linear Motor Design Provides Close and Secure Vehicle Separation of Many Transit Vehicles on a Guideway,” IEEE Transactions on Industrial Electronics, vol. 54, no. 3, pp. 1778-1782, Jun. 2007.
L. N. Tutelea, M. C. Kim, M. Topor, J. Lee, and I. Boldea, “Linear Permanent Magnet Oscillatory Machine: Comprehensive Modeling for Transients With Validation by Experiments,” IEEE Transactions on Industrial Electronics, vol. 55, no. 2, pp. 492-500, 2008.
M. Boussak, “Implementation and Experimental Investigation of Sensorless Speed Control With Initial Rotor Position Estimation for Interior Permanent Magnet Synchronous Motor Drive,” IEEE Transactions on Power Electronics, vol. 20, no. 6, pp. 1413-1422, Nov.
Y.-S. Kung, “Design and Implementation of a High-Performance PMLSM Drives Using DSP Chip,” IEEE Transactions on Industrial Electronics, vol. 55, no. 3, pp. 1341-1351, Mar. 2008.
T.-H. Liu, Y.-C. Lee, and Y.-H. Chang, “Adaptive controller design for a linear motor control system,” IEEE Transactions on Aerospace and Electronic Systems, vol. 40, no. 2, pp. 601-616, Apr. 2004.
Y.-W. Zhu and Y.-H. Cho, “Thrust Ripples Suppression of Permanent Magnet Linear Synchronous Motor,” IEEE Transactions on Magnetics, vol. 43, no. 6, pp. 2537-2539, Jun. 2007.
I. Takahashi and Y. Ide, “Decoupling control of thrust and attractive force of a LIM using a space vector control inverter,” IEEE Transactions on Industry Applications, vol. 29, no. 1, pp. 161-167, 1993.
X. del Toro Garcia, A. Arias, M. G. Jayne, and P. A. Witting, “Direct Torque Control of Induction Motors Utilizing Three-Level Voltage Source Inverters,” IEEE Transactions on Industrial Electronics, vol. 55, no. 2, pp. 956-958, 2008.
F. Morel, J.-M. Retif, X. Lin-Shi, and C. Valentin, “Permanent Magnet Synchronous Machine Hybrid Torque Control,” IEEE Transactions on Industrial Electronics, vol. 55, no. 2, pp. 501-511, 2008.
K. C. Veluvolu and Y. C. Soh, “High-Gain Observers With Sliding Mode for State and Unknown Input Estimations,” IEEE Transactions on Industrial Electronics, vol. 56, no. 9, pp. 3386-3393, Sep. 2009.
Q. D. Nguyen and S. Ueno, “Improvement of sensorless speed control for nonsalient type axial gap self-bearing motor using sliding mode observer,” in 2010 IEEE International Conference on Industrial Technology, 2010, pp. 373-378.
A. Jaafar, E. Godoy, P. Lefranc, X. L. Shi, A. Fayaz, and N. Li, “Nonlinear sliding mode observer and control of high order DC-DC converters,” in IECON 2010 - 36th Annual Conference on IEEE Industrial Electronics Society, 2010, pp. 180-186.
M. Abroshan, K. Malekian, J. Milimonfared, and B. Abdi Varmiab, “An optimal direct thrust force control for interior Permanent Magnet Linear Synchronous Motors incorporating field weakening,” in 2008
International Symposium on Power Electronics, Electrical Drives, Automation and Motion, 2008, pp. 130-135.
A. Hijazi, X. Lin Shi, A. Zgorski, and L. Sidhom, “Adaptive sliding mode observer-differentiator for position and speed estimation of Permanet Magnet Synchronous Motor,” in 3rd IEEE International Symposium on Sensorless Control for Electrical Drives (SLED 2012), 2012, pp. 1-5.
Z. Qiao, T. Shi, Y. Wang, Y. Yan, C. Xia, and X. He, “New Sliding- Mode Observer for Position Sensorless Control of Permanent-Magnet Synchronous Motor,” IEEE Transactions on Industrial Electronics, vol. 60, no. 2, pp. 710-719, Feb. 2013.
Y. Zhao, W. Qiao, and L. Wu, “An Adaptive Quasi-Sliding-Mode Rotor Position Observer-Based Sensorless Control for Interior Permanent Magnet Synchronous Machines,” IEEE Transactions on Power Electronics, vol. 28, no. 12, pp. 5618-5629, Dec. 2013.
S. Chi, Z. Zhang, and L. Xu, “Sliding-Mode Sensorless Control of Direct-Drive PM Synchronous Motors for Washing Machine Applications,” IEEE Transactions on Industry Applications, vol. 45, no. 2, pp. 582-590, 2009.
TECNOTION B.V., “A primer of Tecnotion Linear Motors,” 2008. [Online]. Available: http://www.tecnotion.com/files/Manuals/Basic_ Information_LM_EN_V21_ 20080912.pdf.
J. Chu, Y. Hu, W. Huang, M. Wang, J. Yang, and Y. Shi, “An improved sliding mode observer for position sensorless vector control drive of PMSM,” in 2009 IEEE 6th International Power Electronics and Motion Control Conference, 2009, pp. 1898-1902.
H. Kim, J. Son, and J. Lee, “A High-Speed Sliding-Mode Observer for the Sensorless Speed Control of a PMSM,” IEEE Transactions on Industrial Electronics, vol. 58, no. 9, pp. 4069-4077, Sep. 2011.
Downloads
Published
Issue
Section
License
Copyright (c) 2014 Saeed Masoumi Kazraji, Ramin Bavili Soflayi, Mohammad Bagher Bannae Sharifian (Author)
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 Unported License.
How to Cite
